‘It's time for OSHA to move on a comprehensive regulation to adequately address combustible dust hazards’

Published:  20 February, 2012

US Chemical Safety Board Chairperson Rafael Moure-Eraso in Lexington (KY) writes in the Lexington (KY) Herald leader: Nine years after Corbin explosion, still no dust regulations.

‘On Feb. 20, 2003, powerful dust explosions tore through the CTA Acoustics plant in Corbin, where fiberglass insulation was manufactured for the automotive industry. The loss of seven lives and scores of injuries made the accident one of the state's deadliest.

‘US Chemical Safety Board investigators found that the explosion was fueled by resin dust which accumulated in a production area and that was likely ignited by flames from a malfunctioning oven. The resin involved was a phenolic binder used in producing fiberglass mats.

‘Investigators found that CTA had been aware that combustible dust in the plant could explode, but did not modify the design of the plant to prevent the release and accumulation of the dust, communicate the hazard to workers or modify operating procedures. The CSB also found that Borden Chemical, the manufacturer of the resin, had failed to include adequate safety warnings on the data sheets for the raw material that generated the combustible dust.

‘As a result of the tragedy in Corbin, the CSB issued a number of recommendations to the company, the state of Kentucky, trade associations and others. I am pleased to report the board found the responses to all of those recommendations to be positive and thus the cases were closed.

‘But dust explosions continued to occur elsewhere, leading the CSB in 2006 to recommend that the Occupational Safety and Health Administration should issue a federal regulatory combustible dust standard for general industry, to end these preventable tragedies.

‘Yet, nine years after the CTA catastrophe, and more than five years after our recommendation to OSHA, there is still no comprehensive OSHA standard to prevent these accidents.

‘The same year that the CTA accident occurred, in 2003, a fatal dust explosion at West Pharmaceutical in Kinston, N.C, killed six workers. Then one worker was fatally burned and another seriously injured at a metal dust fire at the Hayes Lemmerz aluminum wheel manufacturing company in Huntington, Ind. In all, 14 workers died from dust explosions in that one year.

‘The safety board launched a study into the hazards of combustible dust. Our 2006 report revealed there is no national regulation that adequately addresses combustible dust explosion hazards in general industry. Although many states and localities have adopted fire codes that have provisions related to combustible dust, a CSB survey found that fire code officials rarely inspect industrial facilities to enforce the codes. The board clearly stated that American industry needs a comprehensive federal combustible dust regulation.

‘Although OSHA agreed to develop a dust standard in April 2009, the agency's most recent 2012 regulatory agenda does not include any specific milestones or targets for the standard's development. Without a standard that comprehensively addresses the hazards of combustible dust, American workers will continue to be put at risk for future catastrophic explosions and fires.

‘Since the tragedies of 2003 that hit Corbin and two other cities, dust explosions continue to take workers' lives. Among the most devastating:

‘On Feb. 7, 2008 combustible sugar dust at the Imperial Sugar Refinery in Port Wentworth, Ga., ignited. The resulting explosions and fire led to the death of 14 workers and injuries to 38 others. The CSB investigated and once again called on OSHA to move forward "expeditiously" with promulgation of a combustible dust standard.

‘Just last year, the Hoeganaes powdered iron metal manufacturing plant in Gallatin, Tenn., had three metal dust flash fires, one precipitated by a hydrogen explosion, over a period of five months, killing a total of five workers. Fine, combustible iron dust had accumulated to dangerous levels on plant surfaces. Workers told CSB investigators that the plant had experienced numerous flash fires but the company failed to take corrective action.

‘Our final investigation report on the Gallatin tragedies included a recommendation that OSHA move forward with a dust standard within one year.

‘Industrial combustible dust explosions are hardly limited to the United States. According to media reports, last year two electronics manufacturers in China that produce parts for Apple Computer products experienced dust explosions when fine particles of aluminum ignited, killing four workers and injuring dozens of others. Apple's Supplier Responsibility documents state that the company is now requiring improved ventilation, inspections and cleaning methods for dust deposits.

‘I don't know what steps China is taking to prevent its dust explosions, but I do know what can be done here in the US. It's time for OSHA to move on a comprehensive regulation to adequately address combustible dust hazards.’

  • Operation Florian

Sign up: eMagazine & eNewsletter

The latest issues in your inbox.

Company Profiles

HazSim - Bringing situational HazMat training to life

HazSim, LLC provides innovative simulation training to ensure your team works safely and effectively. HazSim Pro simulation equipment is in use by hundreds of fire departments, training schools, industrial fire teams, and private trainers across the US, Canada and further afield as well as the US Army.

Revolutionizing fire fighting foam technology

The one-stop resource for fire fighting foam concentrates and custom-designed foam suppression systems hardware.

Advancing rescue technology

The specialist supplier of quality PPE and Rescue Equipment to Emergency Services.

The ultimate in innovation, quality and service

For 60 years Lehavot has been delivering the world’s most advanced fire detection and suppression automatic systems

Trust the best, let us be your foam solution

AUXQUIMIA is a Spanish company whose main activity is the design, manufacture and commercialization of firefighting foam concentrates.

Williams Fire & Hazard Control offers a full line of specialized fire response equipment for oil and gas platforms

From storage tanks and pipeline emergencies to offshore platforms and vessels at sea, Williams' response personnel and specialized equipment quickly address adverse fire emergencies.

Foam fights fire

Europe’s foremost fire fighting foam manufacturer has been developing and producing foams since the 1920s.

The leader in truck-mounted hydraulic platforms

Our mission is to provide the best and the safest solution to professionals that work at height.

The independent alternative

Dafo Fomtec AB is a privately owned company with head office in Stockholm Sweden and manufacturing in Helsingborg in the south of Sweden.

If you want quality, you want Zico

Since its inception Ziamatic Corp has provided the men and women of the fire service with products designed to make their jobs safer and easier.

Calendar